| Member Group
|
Select the member group from the drop-down list in the upper
left corner of the dialog.
|
| Automatically Generated POIs
|
The following two inputs pertain to automatically generated POIs
only:
| Setting | Description |
|---|
| Minimum number of POIs between supports
|
Enter the minimum number of POIs to be generated per span.
By default,
LEAP Bridge Steel will generate
POIs at all cross frame locations and the mid-point between cross frames.
Additional POIs will be located at section breaks if this option is checked and
at user defined POIs (see below).
|
|
| User Generated POI locations
|
The following inputs pertain to User generated POI locations.
These POIs are also referred to as Custom POIs.
| Setting | Description |
|---|
| Insert
|
Press this button to insert a POI before the currently
highlighted line in the grid.
|
| Delete
|
Press this button to delete the currently highlighted POI
in the grid for the current member. Only custom POIs can be deleted.
|
| Delete All
|
Press this button to delete all custom POIs for the
current member.
|
| Regenerate
|
Press the Regenerate button to recompute all POIs based on
the current selections.
|
|
| Copy Locations to
|
From the drop-down list, select the locations where custom POIs
on the current member will be copied. Options are either all members in the
current member group or one or more of the other members in the group.
|
| Location Type
|
In the Grid, select
Absolute to enter or view the location of
the POI in units of feet from the beginning of the member. Select
Relative to enter or view the location as a
fraction of the overall member length.
|
| Location
|
If Location Type is
Absolute, the location will be shown in
feet. If the Location Type is Relative, the location will be shown as a
fraction of the overall member length. Note that this field can only be edited
for Custom POIs.
|
| Description
|
The Description indicates two primary POI groups. One is
Automatically Generated POI with the type
of POI following. See the table below for POI types. The other is
Custom POI. Custom POIs are those entered by
the user.
|
| Save DGN
|
Press this button to export all member group geometry to a
MicroStation .dgn file. Save the .dgn file to the desired location and once the
export is complete you can browse to the file location and open/view it in
MicroStation.
|
| OK
|
Press this button to accept all changes and exit the command.
|
| Cancel
|
Select this button to exit the command without saving changes.
|
